OXYGEN 1st STAGE FOR APD REBREATHER
![](/img/m/34.jpg)
Circular style wing for diving with doubles. STREAM RING 20 was designed for diving with double tanks from 2x7-2x12 and stage. Due to the small profile, along with sufficient lift, this wing is especially suitable for recreational and also tec diving.
Circular style wing for diving with doubles. STREAM RING 20 was designed for diving with double tanks from 2x7-2x12 and stage. Due to the small profile, along with sufficient lift, this wing is especially suitable for recreational and also tec diving.
On / off valve that opens or closes the air flow into the hose line where it is installed. Ideal to place on the second stage regulator due to its small size. Approximate length: 4.5 cm
O-rings box Viton 85 material shore A hardness, compatible with oxygen; with 14 different sizes and 10 units of each measure.
Underwater slate, with a special shape that fits to the wrist or forearm and allows place with other instruments without any disturb.
TDS slate book with 40 waterproof pages and cordura cover with small pockets. Includes graphite pen attached with bungee to one edge of the cover. Allows writing in and out of the water.
The Trieste Double Bladder Wings are designed for the diver that prefers a wing with a redundant bladder. The secondary bladder is designed to ensure proper buoyancy control in the event of primary bladder failure. Horseshoe style, redundant wings are the choice wing picked by divers that are not wearing a drysuit. The redundant bladder is utilized in the rare event that the primary bladder is rendered unusable. The power/oral inflator is the same on both bladders. Overpressure valves are located on the respective sides of each bladder.
The Performance Mono Wing is a donut-style wing allowing quick and easy movement of air from one side of the air cell to the other. It also has stabilizing bars built into the wing to reduce tank shifting during the dive. This is the ideal wing for the traveling diver as it is small, lightweight and easy to pack. The Mono wing will fit onto the IQ pac, Aluminum or Stainless Steel Backplate using the Comfort harness II or Continuous weave (Dir) harness.
Complete harness for mounting a side tank for stage, bailout or side mount. It is valid for aluminum cylinders used in technical diving of the S80 type. The set comes pre-assembled and requires minimal installation by the user, thus customizing the position of the tank.
Complete harness for mounting a side tank for stage, bailout or side mount. It is valid for aluminum cylinders used in technical diving of the S40 type. The set comes pre-assembled and requires minimal installation by the user, thus customizing the position of the tank.
TDS Goodman type handle made of lightweight anodized aluminum. The height of the handle is adjustable by means of a side screw with a wide knob, allowing it to be adjusted to the size of our hand and/or to the use with or without gloves. It is possible to adjust the height in immersion because it is not necessary to use a wrench.
The WTX and WTX-D Series is a selection of harnesses, buoyancy cells and accessories which offer unparalleled versatility due to the modular nature of the whole system. Each component can be configured into a highly technical rig for those trained to push the limits, or scaled down to make a travel friendly set up suitable for any diver
Modular side Right-type valves cap, to close the side exit to exit manifold or modular plug. Matt black finish of the military series.
Modular side Left-type valves cap, to close the side exit to exit manifold or modular plug. Matt black finish of the military series.
Manifold with isolation valve for twins mounting. 171 mm for 10/12 long twins. Matt black finish of the military series.